; The CMD file. ; ; Two parts: 1. Command definition and 2. State entry ; (state entry is after the commands def section) ; ; 1. Command definition ; --------------------- ;-| Double Tap |----------------------------------------------------------- [Command] name = "FF" ;Required (do not remove) command = F, F time = 10 [Command] name = "BB" ;Required (do not remove) command = B, B time = 10 ;-| 2/3 Button Combination |----------------------------------------------- [Command] name = "recovery";Required (do not remove) command = x+y time = 1 ;-| Dir + Button |--------------------------------------------------------- [Command] name = "down_a" command = /$D,a time = 1 [Command] name = "down_b" command = /$D,b time = 1 ;-| Single Button |--------------------------------------------------------- [Command] name = "a" command = a time = 1 [Command] name = "b" command = b time = 1 [Command] name = "c" command = c time = 1 [Command] name = "x" command = x time = 1 [Command] name = "y" command = y time = 1 [Command] name = "z" command = z time = 1 [Command] name = "start" command = s time = 1 ;-| Hold Dir |-------------------------------------------------------------- [Command] name = "holdfwd";Required (do not remove) command = /$F time = 1 [Command] name = "holdback";Required (do not remove) command = /$B time = 1 [Command] name = "holdup" ;Required (do not remove) command = /$U time = 1 [Command] name = "holddown";Required (do not remove) command = /$D time = 1 ;--------------------------------------------------------------------------- ; 2. State entry ; -------------- ; Don't remove the following line. It's required by the CMD standard. [Statedef -1] ;--------------------------------------------------------------------------- ;Stand [State -1, Stand] type = ChangeState value = 0 triggerall = command = "x" trigger1 = statetype = S trigger1 = ctrl